Colorberry Case STLs

This is a slight adjustment to Alex's case design. I changed the back case for the Colorberry to better house the battery, as well as some tolerance for a Command-Strip to be used to hold the battery in place. I also created a new slim SD card cover. The front cover and button are the same as the original. 

NOTE: **Depending on the tolerance of your printer, you may need to slightly sand or cut down the sides of the SD Card cover to properly fit through the slot. I used an Exacto knife and some files to sand somewhat on the edges, just the part that needs to go into the case. 

On the front cover, you may want to add a bit of glue strip or adhesive that can hold the case down around the screen's sides. 

For screws, it should use the same screws as the normal case but for reference, I used M2.5x5, M2.5x6 and M2.5x8. I purchased this box on Amazon a while back, which had what I needed. 

https://www.amazon.com/dp/B0B5CY5LY5?ref=ppx_yo2ov_dt_b_fed_asin_title